Installation – Support

Q: Where to install CO detectors?

We recommend placing at least one CO detector on every floor that has a bedroom close to the bedroom in question. For increased protection, additional detectors could be installed in every bedroom and on every floor of your home. If the bedroom hallway is longer than 12 meters, install a CO detector at each end of the hallway. In houses with one floor: Install at least one CO detector near or in each bedroom. For extra protection, install at least one CO detector in the same room as a fuel-burning boiler or another (fuel) heat source. In houses with two (or more) floors Install at least one CO detector near or in each bedroom. For extra protection, install at least one CO detector on every floor. For extra protection, install at least one CO detector in the same room as a fuel-burning boiler or another (fuel) heat source. In mobile homes Only install a CO detector on the inside walls. Non-insulated walls and roofs of a mobile home carry heat and cold over from the outside. The detector must be installed at least 15cm away from all external walls and at least 30cm away from the ventilation opening.

Q: Where not to install CO detectors?

In garages, kitchens, in rooms where the boiler is located, or in extremely dusty, dirty or oily areas. Within 1.5 meters of cooking equipment. In extremely humid areas. The detector must be installed at least 3 metres away from baths, showers, saunas, humidifiers, vaporisers, dishwashers, washing machines, dryers, utility rooms or other rooms with a high humidity. In rooms where the temperature is below 4° C or above 38° C, for example, crawl spaces, unfinished attics, not or poorly insulated ceilings, carports and garages. In moving air, such as close to ceiling fans, heat exhausts, air conditioners, fresh air supply or open windows. Air currents may prevent carbon monoxide from reaching the sensors. Outside the mobile home. In direct sunlight.

Q: How high should I install my CO detector?

The height of a CO detector isn't very important because CO is a diffuse gas and therefore spreads evenly in a room. CO is about as heavy as air. This means that you can put the CO detector at 'sleeping height' in the bedroom and at 'sitting height' in the living room. In any case, choose somewhere clean, away from children and pets. Always read the manual for the specific installation requirements. Some CO detectors also have a stand so you can easily place it on a cabinet and do not need to mount it to a wall or ceiling.

Q: Where not to place a gas alarm?

It is important to hang your gas alarm in the correct place. Make sure the alarm isn't shielded or covered. This can greatly reduce the sensor's performance. Make sure the alarm doesn't come into contact with moisture. Protect the alarm from strong magnetic fields. Avoid situations where the temperature is less than -10 degrees Celsius or more than 40 degrees Celsius. Do not place the alarm close to strong air currents such as fans, doors, windows, etc. Avoid putting it in humid areas such as bathrooms and showers where the relative humidity can rise above 95%. Closed areas, such as in cabinets or behind curtains, prevent the alarm from detecting a gas leak. Areas where dust or dirt can block the sensor. Directly next to an oven, sink or drain.

Q: Where to install your gas alarm?

A gas alarm is designed for indoor use in dry rooms where a gas leak may occur. It's important to be able to hear the signal clearly in case of an alarm. Detecting natural gas To detect natural gas, you need to install the alarm 15-30 cm below the ceiling, no more than 6 meters away from your stove or gas appliance. Make sure that you have a power outlet for the adapter within 2 metres of the place where you want to install your alarm. Detecting LPG To detect LPG, you need to install the alarm 15-30 cm above the floor, no more than 4 meters away from your stove or gas appliance. Recommended locations are kitchens, garages, caravans and motor homes.

Where to install CO detectors?

Where not to install CO detectors?

How high should I install my CO detector?

Where not to place a gas alarm?

Where to install your gas alarm?